How To Install Velcro

Step 1

Place your laptop on the front panel and determine the best position to place it.   We suggest you should operate the laptop, place the cables etc. to make sure its comfortable and practical. Make sure front of the laptop is behind the black strip and easily clears under the top shelf.  Similarly there should be sufficient clearance in the back so it can easily close with cables and connectors attached.  (When the laptop is attached with Velcro, it will remain suspended.  This also protects your equipment from direct impact). Take a piece of tape or sticker to mark the exact position where you wish to place the laptop.  Now remove the laptop and follow step two.

Step 2

Flip the laptop upside and look for the best place to attach Velcro.  Do not block any vents.  Cut the Velcro (with both hook and loop strips attached) to the desired size.  We suggest it should be at least five inches long.  If you have to split it to access a compartment, etc. it should be OK.  You should locate two places to stick the Velcro strips from front to back.

Step 3

Look for the soft side of the Velcro.  Peel off the plastic from that side only and attach it onto the bottom of the equipment.  Repeat the same for the other strip.   Now you should see both strips attached to the equipment with plastic still attached on the hard side Velcro.

Step 4

Peel off both plastic strips and carefully place the laptop on the shelf on the areas marked by tape or stickers.  Make sure that you do not place the Velcro on the sticker.  Do not press down until you are sure its the right place. Try to hold the laptop and close the case to make that sure its OK.

Step 5

Now lightly press the equipment and let it sit.  We recommend the equipment should remain in place (without closing) for approximately six hours so adhesive on the Velcro would stick strongly.